Universal Repeater - Black Box 11N 2T2R Manual

Option
MAC Address 1-4
Set Security
After you finish the settings, click on the Apply button. The following message will be displayed:
When you see this message, the settings you made are successfully saved. You can click on the Continue button to go back to
the previous page and continue setting other items, or click on the Apply button to restart the wireless access point. The changes
will take effect after about 30 seconds.

3.4.6 Universal Repeater

In this mode, the access point acts as a wireless repeater; it can be configured as station and AP at the same time. It uses the sta-
tion function to connect to a Root AP and it uses the AP function to service all wireless stations within its coverage.
NOTE: In repeater mode, this access point will demodulate the received signal and check if it is noise for the operating network,
then modulate and amplify the signal again. This mode's output power is the same as that of WDS and normal AP mode.
Table 3-9 (continued). AP bridge WDS mode options.
Description
Input the MAC address of the wireless access point you want to connect.
Click on this button to select an encryption mode for this wireless link, and a new popup win-
dow will appear. Refer to Section 3.7 for detailed descriptions.
Figure 3-23. Settings saved successfully prompt.
Figure 3-24. Universal repeater screen.
Chapter 3: Installation and Configuration
Page 31