Cisco ASA 5510 Quick Start Manual page 46

Figure 8 Connecting the LC Connector
1
1
LC connector
Connect the other end of the LC connector to your network device.
c.
After you have attached any SFP ports to your network devices, you must also change the media type
setting for each SFP interface. Continue with the following procedure, "Step 2: (Optional) Setting the
4GE SSM Media Type for Fiber Interfaces."
Step 2: (Optional) Setting the 4GE SSM Media Type for Fiber Interfaces
For each SFP interface, you must change the media type setting from the default setting (Ethernet) to
Fiber Connector.
Because the default media type setting is Ethernet, you do not need to change the media type
Note
setting for Ethernet interfaces you use.
46
L N K
3
2
1
0
S P D
C is c o
S S M -4
G E
2
2
SFP module