Cisco ASA 5510 Quick Start Manual page 29

Step 6: Configure address pools.
For remote clients to gain access to your network, it is necessary to configure a pool of IP addresses
that can be assigned to remote VPN clients as they are successfully connected. In this scenario, the pool
is configured to use the range of IP addresses 209.165.201.1 to 209.166.201.20.
To configure an address pool, perform the following steps:
Enter a pool name, or choose a pre-configured pool from the drop down list.
1.
Enter the start of the range of IP addresses to be used in the pool.
2.
Enter the end of the range of IP addresses to be used in the pool.
3.
Enter the subnet mask, or select a pre-configured value from the drop down list.
4.
Click Next to continue.
5.
29