Service Manual – SC100 - Scrubtec 130
Dosing pump Disassembly/Assembly
Disassembly
1
Set the machine to stop position
2
Make sure that the machine power supply cable is disconnected from the electrical mains
3
Remove the brush
4
Remove two squeegee bars
5
Remove the function electronic board (see the procedure in the relevant paragraph)
6
Remove the sensor receiving the solution level (see the procedure in the relevant paragraph)
7
Disconnect the vacuum hose (A) form the housing (B) of the motor assembly
8
On the lower side of the deck, remove the screws (C)
9
Turn the machine to its original position (D)
10 Press the unlock pedal (E) and fully lower the frame (F)
F
E
B
A
C
D
Solution System
C
C
31