Service Manual – SC100 - Scrubtec 130
Removal and Installation
Disassembly/assembly of the solution level sensor (inside the tank)
Disassembly
4
Set the machine to stop position
5
Make sure that the machine power supply cable is disconnected from the electrical mains
6
Remove and drain the tank assembly
7
On the lower side of the tank assembly, remove the screws (A) fastening the cover (B)
8
Carefully remove the cover (B) with the level sensor (C)
Assembly
9
Assemble the components in the reverse order of disassembly, and note the following:
◦
Before reassembly, check the cover gasket (B) for integrity
B
A
C
Solution System
B
29