Blower Performance Tables - Nordyne P6SP-072 Series Installation Instructions Manual

Single package electric heating / electric cooling rooftop unit

Hide thumbs

Table Of Contents

Table of Contents

This equipment is outfitted with a belt driven blower assembly in order to accommodate a large variety of duct

configurations and airflow selections. The blower has been factory inspected for proper alignment, operation and

rotational direction prior to the drive motor being situated in the shipping position. The blower drive belt is located

with these instructions and must be installed by the service technician. For a more detailed explanation of belt driven

blower drives and the operation of their components please refer to any of the installation instructions listed below

for the high static drive kits.

The factory standard drive installed in these units has been set to deliver 400 Cfm/ton at an External Static Pressure

(ESP) of 0.25-0.30 in-Wg. Tables 5-10 show the full blower curves of these drive configurations and can be utilized

to easily set the adjustable motor sheave for alternate configurations. Refer to the Legend below for a description

of the table information. Once a sheave setting has been made, always inspect the blower amp draw to ensure that

it is less then the service factor amps listed on the motor. For systems that include a large number of accessories

or have very restrictive duct systems, alternate drive kits are available – refer to table 4 below for the applicable

kits. The full blower curves for the HSD kits can be found in the applicable kit installation instructions or in the unit

technical service literature.

3862

1159

3.03

table

3493

1017

legend

2.07

unit Model #

-072C

-072D

-090(C/D)a

-120(C/D)a

notE: Refer to the P6SP TSL or Accessory Kit Installation Instructions for actual blower charts