Installation Of Hanger Bracket - Emerson CF717BS00 Owner's Manual

WARNING
!
The fan must be hung with at least 7' of clearance from
floor to blades (Figure 11).
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
WARNING
!
The outlet box and joist must be securely mounted and
capable of supporting at least 50 lbs. Use only a U.L.
outlet box listed as "Acceptable for Fan Support of 22.7
kg. (50 lbs.) or less".
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable for
Fan Support of 22.7 kg. (50 lbs.) or less", and use screws
supplied with outlet box. Most outlet boxes commonly
used for support of light fixtures are not acceptable for
fan support and may need to be replaced. Consult a
qualified electrician if in doubt.
5.1
Unscrew (but do not remove) the two mounting screws in
the outlet box (Figure 12). Position the hanger bracket on
the outlet box so that the T-slots in the hanger bracket are
aligned with the outlet box screws. NOTE: The hanger bracket must be mounted flush
with the ceiling in order for the ceiling cover to install
properly. If necessary, use leveling washers (not
supplied) between the outlet box and the hanger
bracket.

5. Installation of Hanger Bracket

T-SLOT
Figure 11
HOOK
Figure 12
Please contact 1-800-654-3545 for further assistance
9
OUTLET BOX
LOOSEN TWO
SCREWS (SUPPLIED
WITH OUTLET BOX)
SLIDE THE HANGER
BRACKET ONTO
THE OUTLET BOX
SCREWS, THROUGH
THE T-SLOT
HANGER
BRACKET
SECURELY
TIGHTEN
SCREWS
HANGER BRACKET
emersonfans.com
ETL Model No.: CF717