Alarm setup
Alarm interface is shown as below. See
Alarm in: Here is for you to select channel number.
Event type: There are two types. One is local input and the other is
network input.
Type: normal open or normal close.
PTZ activation: Here you can set PTZ movement when alarm
occurs. Such as go to preset, tour& pattern when there is an alarm.
Click "select" button, you can see an interface is shown as in
.
4-28
Period: Click set button, you can see an interface is shown as in
. Here you can set for business day and non-business
F igure 4-29
7 0 9 H
day. In
F igure 4-29
7 1 0 H
shown as in
F igure 4-30
7 1 1 H
business day and non-business day.
Anti-dither: Here you can set anti-dither time.
Show message: System can pop up a message to alarm you in the
local host screen if you enabled this function.
Alarm upload: System can upload the alarm signal to the network
(including alarm centre) if you enabled current function.
Send email: System can send out email to alert you when alarm
occurs.
Record channel: you can select proper channel to record alarm
video (Multiple choices). At the same time you need to set alarm
record in schedule interface (Main Menu->Setting->Schedule) and
select schedule record in manual record interface (Main Menu-
>Advance->Manual Record).
Latch: Here is for you to set proper delay duration. Value ranges
from 10 to 300 seconds. System automatically delays specified
seconds in turning off alarm and activated output after external
alarm cancelled.
Tour: Here you can enable tour function when alarm occurs.
System supports one-window tour. Please go to chapter 5.3.9
Display for tour interval setup.
F igure 4-27
7 0 7 H
, click set button, you can see an interface is
. Here you can set your own setup for
.
F igure
7 0 8 H
56