Honeywell CADVR-04D User Manual page 68

Show message: System can pop up a message to alarm you in the
local host screen if you enabled this function.
Alarm upload: System can upload the alarm signal to the network
(including alarm centre) if you enabled current function.
Send email: System can send out email to alert you when alarm
occurs.
PTZ activation: Here you can set PTZ movement when alarm
occurs. Such as go to preset, tour &pattern when there is an alarm.
Click "select" button, you can see an interface is shown as in
.
4-22
Period: Click set button, you can see an interface is shown as in
. Here you can set for business day and non-business
F igure 4-23
6 9 9 H
day. In F igure 4-23
7 0 0 H
shown as in
F igure 4-24
7 0 1 H
business day and non-business day.
Anti-dither: Here you can set anti-dither time.
Alarm output: when alarm occurred, system enables peripheral
alarm devices.
Tour: Here you can enable tour function when alarm occurs.
System one-window tour. Please go to chapter 5.3.9 Display for
tour interval setup.
Snapshot: You can enable this function to snapshoot image when
alarm occurs.
Please highlight icon
all the setups please click save button, system goes back to the
previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel
setup since the video in each channel may not be the same.
In , you can left click mouse and then drag it to set a
F igure 4-21
7 0 2 H
region for motion detection. Click Fn to switch between arm/withdraw
motion detection. After setting, click enter button to exit.
click set button, you can see an interface is
. Here you can set your own setup for
to select the corresponding function. After
F igure
6 9 8 H
51