Table of Contents
Advertisement
MAINTENANCE & CLEANING continued
Daily Cleaning (Non chrome only)
•
Empty the grease drawer daily or whenever it is 3/4 full. It is easily removed for washing.
•
Keep the griddle surface clean. After each cooking load, scrape the griddle surface to remove any
carbonized grease.
•
Once a day or when necessary the non chrome griddle surface should be thoroughly cleaned and
seasoned again. Use a griddle stone, griddle pad, or liquid cleaner. Rub with the grain of the
metal, being careful not to scrape the splash guard.
•
Chrome griddle surfaces can be scraped with a 4" wide Razor Sharp scrapper and wipe surface
with a damp cloth.
•
Following the scraping, a damp cloth and non-silicated, non-abrasive, non-chlorinated cleaner such
as Bon-Ami may be used to wipe surface clean, followed by wiping with a clean wet cloth.
Weekly Cleaning (Non chrome only)
•
A mild detergent with water or one of the many commercial cleaners may be used.
•
Be sure to rinse thoroughly and coat the griddle with a thin film of oil to prevent rusting,
non-chrome surfaces only.
•
Clean the exterior of the appliance with hot water and a mild detergent to maintain a gleaming
appearance.
•
Re-season the griddle plate after each cleaning, non-chrome surfaces only.
Burner Air Shutter Adjustment
•
The air shutters are pre-set at the factory.
However, minor adjustments may be required in
the field to accommodate differences in gas and
elevation.
•
To adjust the air shutters, loosen the set screw
holding the air damper to the burner near the gas
inlet.
•
Adjust the air mixture until the burner flame just
flickers on the burner. "Lift-off" or yellow flame
indicates improper shutter adjustment.
•
Periodically inspect and clean the air shutters to
insure complete combustion.
WARNING:
KEEP WATER AND SOLUTIONS OUT OF CONTROLS. NEVER SPRAY
OR HOSE CONTROL CONSOLE, ELECTRICAL CONNECTIONS, ETC.
WARNING
CAUTION:
MOST CLEANERS ARE HARMFUL TO THE SKIN, EYES, MUCOUS
MEMBRANES AND CLOTHING. PRECAUTIONS SHOULD BE TAKEN
TO WEAR RUBBER GLOVES, GOGGLES OR FACE SHIELD AND
PROTECTIVE CLOTHING. CAREFULLY READ THE WARNING AND
CAUTION
FOLLOW THE DIRECTIONS ON THE LABEL OF THE CLEANER TO
BE USED.
NOTICE:
Never leave a chlorine sanitizer in contact with stainless steel
surfaces longer than 10 minutes. Longer contact can cause
corrosion.
Air Shutter
Set Screw
12
Burner
IL2813
Advertisement
Table of Contents
