9.4 Installation
You can install the camera to the ceiling or wall. Follow the steps below.
1.
Install the sun-shield cover to the camera.
A.
Fasten the hexagon screws to the top or bottom of the camera.
IMPORTANT: Do not open the front cover of the camera since
this may impair its resistance to water. The warranty is void if the
seal is broken.
B.
Put the sun-shield cover on top of the hexagon screws. For
optimal sun-shield performance, make sure the rear hexagon
screw is at the end of the opening.
IMPORTANT: The GeoVision logo on the sun-shield cover should
be closer to the front of the camera.
106
Hexagon Screws
Figure 9-2
Figure 9-3