Adapting To Your Environment; Special Functions; Emergency Call Key (Sos) - Mitel 600 Series User Manual

Mitel 600 Series DECT Phone User Guide
such as ringer volume, vibra call, speech quality, LED signaling, etc., adapt to the new
environment. Your DECT phone has five profiles.
The profiles are predefined, but can be changed at any time. If required, change the default
settings to suit your DECT phone applications (see
Note: If, when a profile is activated, you change a number of features in the profile using
the normal menu access (e.g. using Audio > Volume settings), the settings are adopted
by the profile.

ADAPTING TO YOUR ENVIRONMENT

Your DECT phone has two functions that can be used to adapt the device to loud environments:
• Noise detection: If you activate this function (>>> Audio > Ringer settings > Noise detec-
tion menu), the ringer volume is automatically increased in areas with loud ambient noise.
Make sure in this case that you have not set the ringer volume to Increasing.
• Loud environment: If you activate this function using the >>> Audio > Loud environment
menu, the DECT phone attempts to improve the speech quality in a loud environment. This
applies to connections via the DECT phone and with a wired headset, but not to Bluetooth
headsets and the hands-free mode.

SPECIAL FUNCTIONS

EMERGENCY CALL KEY (SOS)

All Mitel 600 DECT phones support storing an SOS emergency call function under one of the
programmable keys (see
briefly press the programmable key (emergency call key). Whether dialing is possible only in the
idle state or also in the connected state depends on the device, the assigned key type, and the
system.
If the SOS emergency call function is programmed under the left or middle softkey, the emergency
call key is available in idle state only.
If the emergency call function is programmed under one of the other keys (left and right navigation
key or sidekeys / Hotkey on the Mitel 620d / 622d / 630d / 632d / 650c), the emergency call key
can also be used in the connection state (depending on the system).
Normally, the DECT phone is switched to hands-free mode when the SOS emergency number
is dialled. On the Mitel 630d/632d, you can set whether the number is dialled in hands-free mode
or in DECT phone operation (see the Handsfree in alarm menu item in the Security menu in
the event of an alarm under Alarm Sensor).
The Mitel 630d and 632d DECT phones have a separate SOS key. You can set the key's response
in the menu >>> > Security > SOS call > SOS key or in the menu >>> > Settings > Key
programming > [press the SOS key].
The settings include:
• SOS call: immediately - dial the SOS emergency immediately.
or
32
"Key programming" on page
"Profiles menu" on page
68). To dial an SOS emergency number,
66).