Projector Control; Overview Flow; Projector Address; Individual Projector Address - Barco FLM R20+ Performer User Manual

13. PROJECTOR CONTROL

About this chapter
This chapter explains the setup of the control part of the software such as projector address and all types of communication with the
external world.
Overview
•

Overview flow

•

Projector address

• Serial communication
• Network
• Local LCD contrast
13.1 Overview flow
Overview
Level 1
Projector control
13.2 Projector address
Overview
•

Individual projector address

• Common address
13.2.1 Individual projector address
About individual projector address
Before a projector, and only this projector, can be controlled via a remote control, an individual address must be entered in the
projector.
This individual projector address can then be used to control the projector via remote control or via a serial connection.
Next to an individual projector address, each projector has also a common address for group control.
How to set an individual address?
1. Press MENU to activate the menus.
R5976921 FLM R20+ PERFORMER 08/03/2006
Level 2
Projector address
Serial communication
Network
Local LCD contrast
Level 3
Projector address
Common address
Baud rate [115200]
DHCP [ON/OFF]
IP-address
Subnet mask
Default gateway
13. Projector control
103