Specifications Flm Hdsdi - Sdi Input - Barco FLM R20+ Performer User Manual

D. Specifications
Input signal
Component Video
- SS
Component Video
- SOY
Specifications
• Data and HD sources RGB and YUV [HS/VS, CS or SOG(Y)]:
- pixelclock maximum 275MHz
- 8 bit digital output
• Mode configurations:
- RGB HS/VS - CS, RGB SOG
- YUV HS/VS - CS, YUV SOY
• Possible to disconnect 75 Ohm terminations on HS and VS (TTL sync level selection)
• Signal requirements:
- Component Video (BNC)
R-Y : 0,7Vpp ±3dB 75 Ohm termination.
o
Ys : 1Vpp ±3dB (0,7V Luma +0,3V Sync) 75 Ohm termination.
o
B-Y : 0,7Vpp ±3dB 75 Ohm termination.
o
- RG(s)B
R : 0,7Vpp ±3dB 75 Ohm termination.
o
G(s) : 1Vpp ±3dB (0,7Vpp G + 0,3Vpp Sync) 75 Ohm termination.
o
B : 0,7Vpp ±3dB 75 Ohm termination.
o
• Diagnostic LED's on front panel:
- Green LED: Lights up in case input module is selected
- Yellow LED: Lights up in case sync detected
D.4 Specifications FLM HDSDI – SDI input
Input front view HDSDI – SDI input
Input 1
Image D-3
154
R / P G / Y
R
P / (R - Y)
R
P / (R - Y) Ys
R
HDSDI - SDI input
Input 2 Loop output
B / P
B
Y
P / (B - Y)
B
P / (B - Y)
B
Sel
Sync OK
R5976921 FLM R20+ PERFORMER 08/03/2006
H / S V
—
S
composite sync
— —