Quick Setup Adjustments; Text Boxes On Or Off - Barco FLM R20+ Performer User Manual

6. Getting started
The Remote connection uses a standard two wire cable terminated on each end with a 3.5 mm male
(mono/stereo) phone jack.
This cable is not delivered but is available in most electronic or audio shops.
Hardwired to the XLR input
1. Plug one end of the remote cable in the connector on the bottom of the RCU
2. Plug the other end in the big connector in the input panel of the projector labelled Remote CTRL in.
Directly to one of the IR sensors
When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line). The
remote control unit will not function properly if strong light strikes the sensor window or if there are obstacles between the remote
control unit and the projector IR sensor.
45°
45°
Image 6-6
RCU to one of the IR sensors
6.5

Quick setup adjustments

Overview
•

Text boxes ON or OFF

• Quick Lens Adjustment
• Quick picture in picture
6.5.1 Text boxes ON or OFF
Text toggle function
The on-screen text boxes can be switched OFF so that an adjustment during the operation of the projector are not visible on the
screen. The adjustment indication remains visible on the local LCD screen.
To toggle Text ON or OFF, press the TEXT key on the remote control or local keypad.
46
45°
45°
R5976921 FLM R20+ PERFORMER 08/03/2006
5-cable input
Sel
Sync OK
R/PrG/Y/Video B/Pb H/S V/Cs
DVI input
Sel
Sync OK
HDSDI - SDI input
1 2 3 4 5 MENU EXIT
Sel
6 7 8 9 0
Loop output Sync OK
Input 1Input 2
RGB PATTERN WINDOW PIP LENS
STBY PAUSE TEXT AUTO RIGGING ENTER
Diagnostic code IR receiver
10/100 Based-T Remote Remote
Std/ON
Port 1 Port 2 CTRL in CTRL outRS232/422 out
Warning IR
PUSH PUSH
2 1 2 1 RS232/422 in
USB PC Card 3 3
45°
45°