Troubleshooting; Error Codes - Barco FLM R20+ Performer User Manual

C. TROUBLESHOOTING
C.1 Error codes
Overview
When the error code is preceded by a '-' sign, then the error means a real error for the projector.
When the error code is preceded by a '+' sign, then the error code means a warning. The projector does not fail yet, but take care
for the warning and try to resolve the problem. A warning state can turn into an error state.
Not all error codes can have two states. When the state is available, it is indicated by a Yes in the overview table. When the state
is not available, it is indicated by a No.
Error Description
code
2000 No lps
detected
4199 FIB reset
failed
1697 Formatter init
failed
1696 Formatter ctrl
init failed
1695 Red form.
start failed
1694 Green form.
start failed
1693 Blue form.
start failed
1692 Form.
PWRGood
1000 Wrong lamp
parameters
↓
1017
2002 Lamp start
failed
2201 PFC start
failed
2501 PFC start
failed
2801 PFC start
failed
2202
LPS start
failed
2502 LPS start
failed
2802 LPS start
failed
R5976921 FLM R20+ PERFORMER 08/03/2006
Error Warn- Caused by
ing
-
Yes no communication with lamp power
supply
-
Yes no communication with FIB
-
Yes
no communication with formatter
ctrl
-
Yes no communication with formatter
ctrl
-
Yes no communication with red
formatter
-
Yes no communication with green
formatter
-
Yes no communication with blue
formatter
-
Yes
formatter 'Power Good' signal not
OK
-
Yes Wrong lamp/ no communication
with lamp
-
Yes Hot restrike
Lamp with many strikes
maximum run time exceeded
Lamp or LPS or SPG failed
-
Yes LPS (address 0x20)
-
Yes LPS (address 0x22)
-
Yes LPS (address 0x28)
-
Yes
-
Yes
-
Yes
C. Troubleshooting
Action
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Call a qualified service engineer
Check lamp type
Call a qualified service engineer
Let cool down the lamp for at least
5 minutes. Retry a few times.
Replace the lamp with a new one
Replace LPS or SPG or cabling.
Replace LPS
Replace LPS
Replace LPS
Replace LPS
Replace LPS
Replace LPS
145