Operation
Taking out the memory card
Memorycard,
When taking out the card, always proceed systematically as described
below, to avoid any loss of your data.
Always wait until the data access has been completed before taking
the card out of the slot.
If your reader has a status display, remove the card only once this has stopped flashing.
Displays on the machine
Operationaldisplay
Machine
The displays appear on the front of the casing.
The displays available for your machine depend on which expansion stage you have selected.
Memory card reader status display
•
The display lights up continuously: A memory card has been inserted.
•
The display flashes: The memory card is being accessed.
•
The display remains unlit: There is no memory card in the reader.
Operational display
Operationaldisplay
Do not disconnect the machine from the mains whilst in power-saving
mode, otherwise data may be lost.
•
The display lights up white: The machine is switched on.
•
The display flashes white: The machine is in power-saving mode. After switching
on at the on/off switch the machine switches on or reverts to the status it was
in before power-saving mode was initiated.
•
The display flashes yellow: The hard disk is being accessed.
•
The display remains unlit: The machine is not connected to the mains or is not ready for
operation. If the machine is ready for operation, it can be switched on at the on/off switch.
16
► If your reader has a card interlock: Press
► Take the memory card out of the slot (2).
1
2
on the memory card (1).
Memory card,
The memory card is now released
and can be taken out.
AMILO Desktop Operating Manual, edition 3