Setting Up The Device; Connections And Controls; Connections - Fujitsu AMILO Operating Instructions Manual

Setting up the device

Ergonomic Device, Videoworkstation
When installing your device, please read the recommendations and
safety notes in the "Safety" manual.
Do not place the machine in any position other than the one intended (upright on its feet).
We recommend that you place your device on a surface with good anti-slip qualities.
In view of the multitude of different finishes and varnishes used on furniture, it is
possible that the rubber feet will mark the surface they stand on.
Do not stack several devices on top of each other.
Do not start the machine in any position other than upright on its feet.
Depending on the location of your machine, it may emit annoying vibration or noises.
To avoid this, allow a minimum clearance of 3 mm from other equipment or objects
at the sides of the casing where there are no ventilation grilles.
Make sure that the device is adequately ventilated. In order to avoid overheating,
do not cover the ventilation area of the monitor or the device.
Do not expose the device to extreme ambient conditions (see
52, "Ambient conditions"). Protect the device against dust, humidity and heat.

Connections and Controls

This chapter describes the individual hardware components of your machine. It gives
you an overview of the displays and connections of the machine . Familiarise yourself
with these elements before you start to use the machine.

Connections

Description
PC power supply
Sound (external sound sources, e.g.
active loudspeaker, microphone)
• Sound onboard
When an additional sound card is
installed, there is no sound function
on the motherboard, and "Sound
onboard" is not available.
AMILO Desktop Operating Manual, edition 3
Figure
Mains connection
3.5 mm jack sockets
Getting started
"Technical data", Page
Symbol
Line In
Line Out
Mic
7