Table of Contents
Advertisement
FabiaTech Corporation
This chapter introduces the system connectors & jumper settings, and guides you to
apply them for field application.
Before Installation
Before you install the system, make sure you follow the following descriptions.
1. Before removing the cover, shut down the operation System and disconnect
power switch to off and unplug AC-to DC Adapter cable.
2. Install any connector, CFast and hard disk is sure that the power is
disconnected or power switch to off from the system. If not, this may damage
the system.
3. The ESD (Electricity Static Discharge) may be created from human body that
touches the board. It may do damage to the board circuit.
Chapter 2 Hardware Installation
6
Advertisement
Table of Contents
