Dataton PICKUP Production Manual page 39

The purpose of this is to avoid accidental cloning of PICKUP units. The switch has to be set
before the charger will start cloning a master PICKUP. Gently insert a straightened paper
clip into the hole until it clicks. Keep the paper clip in place for approximately two seconds,
then remove it. The light on the top of the master PICKUP will start flashing to indicate that
copying is now in progress.
4) When all the files have been downloaded to the charger, the light will either pulsate
slowly (if the battery is not completely charged) or shine steadily. You may now disconnect
the master PICKUP.
Note > The recipient PICKUP units do not have to be in the charger during copying. The
contents of the master PICKUP are downloaded and stored in the charger, then copied to
the PICKUP units when you insert them into the charger.
Note >
Do not disconnect the master PICKUP unit while copying is in progress as this may
damage the files in both the PICKUP and charger.
4 0 |
P I C K U P – P R O D U C T I O N G U I D E