Breckwell SWC31 Owner's Operation And Instruction Manual page 3

Tools and Materials Needed For Installation
You will need a drill with a 1/8" bit to install sheet metal screws into connector pipe. A 5/16" socket/wrench or screw driver to install
pedestal trim, room air defl ector, and blower assembly described below. A 1/2" socket/wrench to install fl ue collar. A non-combustible
fl oor protector as specifi ed in this manual. All chimney and chimney connector components required for your particular chimney
installation. For mobile homes, see page 13.
Assembly
Flue Collar Assembly:
1. Mount the fl ue collar to the top of the unit as shown using the (3) 5/16-18 x 1-1/2 bolts, (3) washers, and (3) weld
tabs provided in the parts box.
Room Air Defl ector Assembly:
1. Locate the Room Air Defl ector. Using the three(3) 1/2 Tek Screws provided, mount the defl ector to the unit as
shown in the diagram.
Firebrick Confi guration:
1. Replace the Firebrick as shown in the illustration below.
Ussc
Side view of fl ue collar
mount to heater top
Brick Confi guration
5/16-18 x 1-1/2
BOLT
HEATER
TOP
WELD
TAB
3