General Slideout Care - Winnebago Cambria Owner's Manual

SECTION 10
SLIDEOUT / LEVELING
Models 26A or 29H
Front Slideout Room Motor/Gear Assembly
(view from ground)
Use 12-point
Use 12-point
socket and ratchet
socket and ratchet
on gearshaft to
on gearshaft to
crank room in
crank room in
Model 29H
Rear Slideout Room Motor/Gear Assembly
(view from access panel at foot of bed)
Crank the room in until it is just 'snugged up'.
Do not overcrank or you could damage the gear
assembly.
Fasten the travel strap before driving the
vehicle to your dealer for service of the slideout
mechanism.
See your dealer for service of the slideout
system before using again.
Further Information
See the Slideout Room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
10-4

GENERAL SLIDEOUT CARE

• Wipe outer seals occasionally with talc or 303
brand protectant for smooth quiet operation.
• Clean the floors inside before retracting the
room to avoid vinyl flooring scratches or
carpet pile snags.
• Be sure there are no obstruction items at end
of bed or behind the driver seat or in
compartments. Some items could be crushed
or cause damage to floor covering or cabinets
when the room is retracted.
• See your authorized dealer for regular
maintenance and service of the mechanism.