Tv Antenna; Tv Signal Amplifier - Winnebago Cambria Owner's Manual

SECTION 8
ENTERTAINMENT

TV ANTENNA

The TV antenna on your motor home can be
easily raised, rotated a full 360° and lowered
from inside the vehicle by simply turning a crank
or directional handle. A built-in signal amplifier
designed to strengthen signals, is controlled by a
power switch built into the video control center.
The signal amplifier is housed inside the
antenna with the circuit board connected directly
to the antenna elements. Power to operate the
amplifier (12-volt DC) is supplied through the
downlead cable which also carries the TV signals
to the TV set. The power supply separates the 12-
volt DC from the TV signals and provides a place
for attaching the TV set and the 12-volt power
source.
Operation
Raising Antenna
Turn elevating crank clockwise in "UP"
direction until some resistance to turning is
noted. Antenna is now in operating position.
Turn amplifier power switch "ON" to receive TV
signal.
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
Rotating Antenna
Make sure antenna is in the "UP" position.
Pull down on directional handle until it
disengages ceiling plate and rotate for best
picture and sound on TV set.
8-2
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional
handle aligns with pointer on ceiling plate.
Turn elevating crank (counterclockwise) in
"DOWN" direction until resistance is noted.
Antenna is now locked in travel position. Turn
amplifier power switch "OFF".
CAUTION
Always align directional handle to
"DOWN" position before lowering.

TV SIGNAL AMPLIFIER

NOTE:For coaches without the video control
center option, be sure the TV antenna
amplifier switch is turned OFF while
connected to cable. The antenna
amplifier will make the cable TV signal
snowy.
To operate amplifier, turn on the power
switch.