6.10.2.3 Inserting the EP10 in the Vehicle Cradle
The Unpowered Vehicle Cradle is equipped with a spring so that it can stretch up as the EP10 is inserted and
then snap back into place to hold the hand-held securely when the EP10 is released. You do not need to
remove the hand-strap to insert the hand-held in the cradle. To insert the EP10 in the Unpowered
Vehicle Cradle:
•
Insert the top of the EP10 into the top of the cradle, and push the EP10 upward while you align the
bottom of the EP10 with the base of the vehicle cradle.
•
Release the EP10 to allow the cradle to snap into place, firmly gripping the hand-held.
6.10.3
Charging Cable RV6008
Power can be added to the Unpowered Vehicle Cradle using an optional charging cable, model number
RV6008. When attached to the cradle, the RV6008 Charging Cable can be connected to the EP10 16-pin
docking connector providing a female DC jack connector that is compatible with standard vehicle power
adaptors like the RV3050 Vehicle Power Adaptor or other standard adaptors that provide 5V, 2A DC.
6.10.4
Vehicle Cradle Mounting Recommendations
For mounting information, refer to Section 6.11.1 on page 211.
6.10.5
Cleaning the RV1000 Vehicle Cradle
Important: Dampen a soft cloth with mild detergent to wipe the unit clean.
•
Use only mild detergent or soapy water on a slightly damp cloth to clean the RV1000. Avoid abrasive
cleaners, solvents or strong chemicals for cleaning. The plastic case is susceptible to harsh chemicals.
The plastic is partially soluble in oils, mineral spirits and gasoline. The plastic slowly decomposes in
strong alkaline solutions.
•
To clean ink marks from the label, use isopropyl alcohol.
Chapter 6: Peripheral Devices & Accessories
Charging Cable RV6008
Psion EP10 Hand-Held Computer User Manual
209