Advertisement
6
LED Description
Follow the drawing below, and the successive table.
Armed Indicator:
The green ARMED light
provides the system Arm
status as follows:
Off: System is
disarmed.
Blinks once every
four seconds:
Partition #1 armed
Blinks twice every
four seconds:
Partition #2 armed
Blinking: System is in
Entry or Exit Delay
Time.
Lit constantly: Entire
system armed (both
partitions)
System Fault LED:
The red FAULT light
blinks when a fault is
detected.
Status and Faults Indicator: When a fault or system status change
occurs, a corresponding Status/Fault LED is turned ON, as follows:
Status/Fault
LED
Indicates an alarm in one of the zones during the last
system ARM period; To view which zone was alarmed,
MEMO
press and hold
alarmed zone LED is turned ON.
Indicates that one or more of the zones have been
bypassed To view which zone/s were bypassed, hold
BYPASS
and press
zone LED is turned ON.
MAINS
Indicates a failure in the Mains power supply (AC fail).
BATT
Indicates a failure in the battery & low voltage.
TEL
Indicates line failure or communication fault.
User manual RXN-406 Keypad for CAPTAIN-i Alarm System
1
2
3
4
MEMO
BYPASS
MAINS
Description
key until the corresponding
key until the corresponding bypassed
RX-406
5
6
BATT
TEL
Zone Status:
The six red lights in the
display area of the keypad
provide the zone status
information for the six
corresponding numbered
zones, as follows:
Off: Zone is closed.
On: An alarm was
triggered while the
system was previously
armed, and this event
has been stored in
memory.
Blinking: Zone is open.
Status & Faults Indicator:
When there is a Fault in the
system, each light
corresponds to a particular
system status or fault (see
table below).
Advertisement
