Stratasys Dimension Elite User Manual page 21

6. A new window, Add 3D Printer, should list your printer in the main window (identified by its
UDN). Click on the printer in this window and enter a name and location in the lower portion
of the window.
7. Click Add Printer and you are ready to print. Close the Add 3D Printer window.
Note:
using a dynamic network and you will need to set up a static network address.
Establishing communication on a static network:
If you are using a static network or connecting the printer directly to a workstation, you will need to
enter the static IP address information into the workstation and the printer. If you are using a static
network and your computer already has network access, see
on page 18
1. Set the static IP address information in the workstation:
a. For Windows XP, see
on page 17
b. For Windows Vista, see
Vista:" on page 17
c. For Windows 7, see
page 18
2. Set the static IP address information in the printer, see
on page 18
Establish communication, see
3.
Setting the static network in Windows XP:
1. From your workstation open the Control Panel and double click on Network Connections.
2. Right click on Local Area Connection and then left click on Properties.
3. Select Internet Protocol (TCP/IP) from the list.
4. Click on the Properties button.
5. Click on the Use the following IP address option.
6. Enter the IP Address, Subnet Mask and Default Gateway. Contact your IT Administrator or
Internet Service Provider for details regarding IP address information. The IP address should be
different from the workstation, the default gateway and subnet mask should match the
workstation. Enter the IP address, default gateway and subnet mask.
7. Click on the OK button when finished. Close any open networking windows.
Setting the static network in Windows Vista:
1. From your workstation click on the Start Menu.
2. Click on the Control Panel button.
3. Double click on Network and Internet.
4. Double click on the Network and Sharing Center icon.
5. Left click on Manage network connections.
6. Right click on the Local Area Connection icon then left click on Properties.
7. Select Internet Protocol Version 4 (TCP/IPv4) from the list.
8. Click on the Properties button.
If your printer is not displayed in the "Add 3D Printer" window, you are not
"Setting the static network in Windows XP:"
"Setting the static network in Windows
"Setting the static network in Windows 7:" on
"Establish communication:" on page 19
"Setting the static network on printer:"
"Setting the static network on printer:"
17