Installing System Software On Printer - Stratasys Dimension Elite User Manual

7. Use the three functions listed above to set your IP address.
8. After setting the final digit of the Internet Protocol (IP) address, move the cursor one more place
to the right. The cursor moves to the Netmask (NM) address. Follow the same steps for setting
the Netmask (NM) and Gateway (GW) addresses.
9. When you have finished setting the addresses, press Done. The display will show: Change IP,
Netmask and Gateway?
10. Press Yes. The panel then displays Resetting Network.
1 1. Press Done until Idle is displayed.
Establish communication:
1. From your workstation, start CatalystEX.
a. From the General tab, click the Manage 3D Printers button.
b. Click the Add from Network button in the lower right corner of the
window.
c. A new window, Add 3D Printer, should list your printer (identified
by its UDN). Click on the printer in this window and enter a name
and location of your choice in the lower portion of the window.
d. Click Add Printer to complete. Close the Add 3D Printer window.
2. If your printer is not displayed in the Add 3D Printer window, you will need to add the printer
IP address manually.
a. From the General tab, click the Manage 3D Printers button.
b. Click the Add Manually button in the lower right corner of the
window.
c. In the Add 3D Printer window, enter a name and location of your
choice in the appropriate fields.
d. Enter the IP Address for your printer in the appropriate field. It will
be the same address as entered in step 6.
e. Select your printer type from the drop down list.
Note:
Click Add Printer and close the Add 3D Printer window.
f.
3. If you are unable to connect the printer to your workstation, contact your Network
Administrator.

Installing System Software on printer

1. From the display panel, press Maintenance.
2. Press System.
3. Press Load Upgrade. "Send upgrade from workstation" and the printer IP address will be
displayed.
4. From your workstation, open CatalystEX by double clicking on the CatalystEX icon.
5. Click the Printer Services tab.
6. Select your printer from the drop down list then click the Update Software button.
If you only have one printer connected, it will be the only printer in the list.
19