Maintenance; Daily - Stratasys Dimension Elite User Manual

5

Maintenance

Follow the simple procedures within this chapter to ensure continued proper operation of the
Dimension printer.
Startup Kit Tools
The Startup Kit contains replacement parts and a set of tools used to help you maintain the
system.The following is a list of the tools contained in the Startup Kit.
• Needle Nose Pliers
• Allen Wrench Set
• Leather Insulated Gloves (Pair)
Cutters
•
• Soft-bristled Glue Brush
• Brush (bronze)
1
• ⁄ " Nut Driver
4
• #2 Phillips Head Screwdriver
• Tube Anti-Seize Compound
Preventive Maintenance

Daily

Inspect the tip wipe assembly
After each build you should inspect the tip wipe assembly to make sure there is no material build
up. If there is material build up, clean the tip wipe assembly. Material build up on the tip wipe
assembly can cause part quality issues. See
page 39
Remove debris buildup
Remove all material buildup on the Z platform and around the lead screw. Failure to do so could
cause the base to not be level or the Z platform to jam at its upper limit.
Vacuum build chamber
Vacuum the build chamber to remove all debris and purged material.
"Tip Wipe Assembly (Brush/Flicker Assembly)" on
36