Removing A Sim Card; Turning The Device On Or Off; Powering Off Or Rebooting A Device - Multitech QuickCarrier MTD-H5 User Manual

3. Verify that the SIM card fits into the holder properly and replace the cover.

Removing a SIM Card

To remove a SIM card:
Warning: If the device is connected to a computer or power supply, disconnect it. Inserting or removing a SIM
card with the device powered may harm the SIM card and the device.
1. Remove the SIM cover from the back of the device. If you have trouble sliding the SIM cover, use a flat-
blade screwdriver in the slot on the SIM cover to slide it out.
2. Slide the SIM card out.
3. Replace the SIM cover.

Turning the Device On or Off

This USB-powered device does not have a power button. Connecting the device to a computer's USB port turns it
on.
■
After plugging in the device, give it time to initialize before using.
■ When the PWRMON line gets to high, the device has powered on.
■
Wait 10 seconds for the device to reach activation state.
Disconnecting it or shutting off the computer, turns it off. For best practices, follow the steps in Powering Off or
Rebooting a Device.
Note: When reconnecting the device, use the same USB port that you used when installing drivers. Otherwise,
you may need to re-install the driver.

Powering Off or Rebooting a Device

To power off your device:
1. Suspend dial-up network.
TM
QuickCarrier USB-D MTD-H5 User Guide
GETTING STARTED
13