Assembly Instructions - Shark KG-252437 Operator's Manual

Alignment
Holes
Frame
Handle
Assy.
Attach the handle to the
frame of the pressure washer. Note:
It may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
Spray
Pressure Hose
Gun
ety
Latch
STEP 4: Attach the high pressure
hose to the spray gun using tefl on
tape (not included) on hose threads.
Pressure
Nozzle
Wand
Coupler
Coupler
Collar
STEP 6: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Garden
Hose
Pump
Water Inlet
STEP 9: Check inlets fi lters, re-
move debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.

ASSEMBLY INSTRUCTIONS

Knob
STEP 2: Insert the carriage bolt
through the holes from the back of
the unit and attach a knob from the
front of the machine. Tighten Knobs
with by hand.
High
Wand
Attach wand to spray gun/
wand. Tighten both.
High
Pressure
Hose
STEP 7: Connect the high pressure
hose to the discharge nipple.
Bolt
STEP 3: Attach the Gun & hose
hanger and insert nuts and wash-
ers from inside. Tighten nuts. (Hose
hanger position: see "COMPO-
NENT IDENTIFICATION")
Spray
Gun
STEP 5: Pull spring-loaded collar
of the wand coupler back to insert
your choice of pressure nozzle.
Discharge
Nipple
STEP 8: Connect garden hose to
the cold water source.
v. 02/14
Gun &
Hose
Hanger
Nut
Washer
Pressure
Nozzle
Wand
Coupler
Cold
Water
Source
Garden
Hose