Assembly Instructions - Shark DE-2010 Operating Instructions Manual

Handle
Alignment
Holes
Frame
Assy.
STEP 1: Attach the handle to the
frame of the pressure washer.
Note: It may be necessary to move
the handle supports from side to
side in order to align the handle so
it will slide over the frame supports.
Safety
Latch
High Pressure
Hose
STEP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
Pressure
Wand
Nozzle
Coupler
Wand
Collar
STEP 7: Release the coupler col-
lar and push the nozzle until the
collar clicks. Pull the nozzle to
make sure it is seated properly.
Pump
Water Inlet
Garden
Hose
STEP 10: Connect the garden hose to
pump water inlet.
CAUTION: Do not run the pump with-
out water or pump damage will result.
6

ASSEMBLY INSTRUCTIONS

Carriage
Bolt
STEP 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
Spray
Gun
Nozzle
Extension
STEP 5: Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
Coupler Collar
STEP 8: Connect the high pressure
hose to the pump discharge fitting.
Push coupler collar forward until
secure.
Inspect inlets.
96-720, 97-708, 97-709, 97-710 • REV. 8/04
Bolts
Nut
STEP 3: Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
Spray
Gun/Wand
STEP 6: Pull the spring-loaded col-
lar of the wand coupler back to in-
sert your choice of pressure nozzle.
Pump Discharge
Fitting
High
Pressure
Hose
STEP 9: Connect garden hose to
the cold water source.
Hose/Gun
Storage
Bracket
Nut
Studs
Pressure
Nozzle
Wand
Coupler
Cold
Water
Source
Garden
Hose