Assembly Instructions - Shark DE-2010 Operating Instructions Manual

Handle
Alignment
Holes
Frame
Assy.
STEP 1: Attach the handle to the
frame of the pressure washer.
Note: It may be necessary to move
the handle supports from side to
side in order to align the handle so
it will slide over the frame supports.
Spray
Gun
Safety
Latch
High Pressure
Hose
STEP 4: Attach the high
pressure hose to the spray
gun using teflon tape on
hose threads.
Pressure
Nozzle
Wand
Collar
STEP 7: Release the coupler col-
lar and push the nozzle until the
collar clicks. Pull the nozzle to
make sure it is seated properly.
6

ASSEMBLY INSTRUCTIONS

Carriage
Bolt
STEP 2: Insert the carriage bolt through
the holes from the outside of the unit
and attach a nut from the inside of the
machine. Tighten nuts.
Nozzle
Extension
STEP 5: Attach nozzle extension to spray
gun/wand. Tighten both by hand.
Wand
Coupler
Coupler Collar
STEP 8: Connect the high pressure
hose to the pump discharge fitting.
Push coupler collar forward until
secure.
Pump
Water Inlet
STEP 10: Connect the garden hose to pump water inlet.
Inspect inlets. CAUTION: Do not run the pump without
water or pump damage will result.
96-720, 97-708, 97-709, 97-710 • REV. 2/04
Nut
Spray Gun/
Wand
STEP 6: Pull the spring-loaded col-
lar of the wand coupler back to in-
sert your choice of pressure nozzle.
Pump
Discharge
Fitting
High
Pressure
Hose
STEP 9: Connect garden hose to
the cold water source.
Garden
Hose
Bolts
Hose/Gun
Storage
Bracket
Nut
Studs
STEP 3: Attach the spray gun/
hose storage handle, and
bracket to handle. Tighten nuts.
Pressure
Nozzle
Wand
Coupler
Cold
Water
Source
Garden
Hose