Fuel Flow Calibration In A Suzuki Engine Interface - Lowrance LMS-522c iGPS Installation And Operation Instructions Manual

ration menu. A list of network devices will be at the top of the page.
3. Select the desired EP-15 Fluid Level and press
4. Press ↓ to select
menu will appear.
5. Highlight
N
Make sure your tank is empty, then highlight
6.
. Select
ENT E
MPTY LEVEL
Select
7. C
ALIBRATE
Empty Level Calibration Completed. Press
Add 1 quarter tank of fuel, highlight
8.
1 Q L and press ENT.
TR EVEL
9. Select C
ALIBRATE
Qtr Level Calibration Completed. Press
10. Add another quarter tank of fuel, which should raise the fuel level
to half a tank. Highlight
press
ENT.
Highlight
11.
pear: Half Level Calibration Completed. Press
12. Add another quarter tank of fuel, which should raise the fuel level
to 3 quarters of a tank. Highlight
and press
L
EVEL
Select
13. C
ALIBRATE
Qtr Level Calibration Completed. Press
14. Top off the tank, highlight
and press
L
EVEL
Select
15. C
ALIBRATE
Full Level Calibration Completed. Press
edly to get back to the main display.

Fuel Flow Calibration in a Suzuki Engine Interface

The default calibration for the Suzuki Engine Interface is adequate in
most cases, but if Fuel Used readings are off by more than 3 percent,
calibration is recommended.
To check engine interface accuracy:
Select Fuel Used to be shown as Overlay Data on your unit's main dis-
play. Refer to the Overlay Data segment of this manual for instructions
on how to select Fuel Used data as Overlay Data.
1. After selecting Fuel Used as overlay data, fill up your tank and press
| .
MENU MENU
2. Select
NMEA 2000
C
ALIBRATE
, press
P ENT
UM TS
and press
and press
and press ENT
F
LUID
and press
C
ALIBRATE
ENT.
and press
ENT.
and press
and press
and press
ENT
and select
5
ENT.
. The following message will appear:
ENT
ENT
F
LUID
. The following message will appear: 1
ENT
and press
L
EVEL
. The following message will ap-
ENT
F L
LUID EVEL
. The following message will appear: 3
ENT
ENT
F L
LUID EVEL
. The following message will appear:
ENT
ENT
.
ENT
224
.
ENT
. The Device Calibration
. Press .
ENT
F L
LUID
.
and press
L
EVEL
.
. Select
ENT
.
ENT
and press
ENT
.
and press
ENT
, then press
and press
EVEL
. Select
ENT
and
H
ALF LEVEL
. Select
3 Q
TR
. Select
F
ULL
repeat-
EXIT