Chapter 13. Attaching to a Novell NetWare host
This chapter provides instructions, requirements, and considerations for attaching a
Novell NetWare host system to a storage unit.
Attaching with fibre-channel adapters
This section describes how to attach a storage unit to a Novell NetWare host
system with fibre-channel adapter cards.
Attaching a Novell NetWare host with fibre-channel adapters
This section list the fibre-channel adapters for Novell NetWare hosts.
This section describes how to attach a storage unit to a Novell NetWare host
system with the following adapter cards:
v Emulex LP9002L adapter card
v Emulex LP9002DC adapter card
v Emulex LP9402DC adapter card
v Emulex LP9802 adapter card
v Emulex LP 10000 adapter card
v Emulex LP 10000DC adapter card
v QLogic QLA2310F adapter card
v QLogic QLA2310FL adapter card
v QLogic QLA2340FL adapter card
v QLogic QLA2342FL adapter card
For a list of open-systems hosts, operating systems, adapters and switches that
IBM does not support, see the Interoperability Matrix at
http://www.ibm.com/servers/storage/disk/ds6000/interop.html.
Fibre-channel attachment considerations for a Novell NetWare host
Fibre-channel attachment considerations for a Novell NetWare host
For up to date information about the switch and fabric connections that IBM
supports, see the Interoperability Matrix at
http://www.ibm.com/servers/storage/disk/ds6000/interop.html.
Installing the Emulex adapter card for a Novell NetWare host
This section tells you how to attach a storage unit to a Novell NetWare host system
with an Emulex adapter card.
Note: The Emulex LP9402DC adapter card is a 3.3 volt card only and requires a
Single- and dual-port, fibre-channel interfaces with an Emulex adapter card support
the following public and private loop modes:
v Target
v Public initiator
v Private initiator
v Target and public initiator
© Copyright IBM Corp. 2004, 2005
3.3 volt PCI slot.
135