IBM TotalStorage DS6000 Attachment Manual page 178

6. Specify the storage units for the host attachment field by selecting a storage
7. Complete the fields in the Specify storage unit parameters page.
8. In the Verification page, review the attributes and values to verify that they are
148
DS6000 Host Systems Attachment Guide
v Select the WWPN from the list. To do this, you must have already zoned the
SAN Volume Controller with a storage unit, and the SAN Volume Controller
must be turned on.
v Manually enter the WWPN for the host port.
Note: A configuration command fails if you use a WWPN that equals zero
(0).
Click Next. The Create Host System – Specify storage units page is displayed.
unit from the Available storage units list and clicking Add. Click Next to display
the Create Host System – Specify storage unit parameters page.
Note: If you select the Create a Storage Unit button (Simulated only), follow
the process for creating the new storage unit. Once you have completed
that process by clicking the Finish button, the new storage unit is
available for selection.
a. Select a host attachment ID.
b. Select a storage group.
c. Choose a login option.
You can loop through this page for each host attachment identifier by clicking
the Apply Assignment button to commit the current transaction and then
starting the procedure again by selecting another identifier. If you select an
existing host attachment identifier from the table, you can click the Create a
new group button to create a new volume group for selection. If you decide
that this host attachment can log in to The following specific storage image
ports, you must specify the specific ports in the Available I/O storage ports
table.
When you are finished specifying the storage unit parameters, click Ok. The
Create Host System – Verification page is displayed.
correct. If the attributes and values are not correct, click Back as appropriate to
return and specify the correct values. Otherwise, click Finish to complete the
host system creation process.