Installing The Kgpsa-Xx Adapter Card In An Tru64 Unix Host System; Example Of The Sizer -V Command - IBM TotalStorage DS6000 Attachment Manual

If you use the storage unit volumes member boot disks for a clustered or
nonclustered configuration, install the operating system from the console level. You
can use the storage unit LUN as a boot disk only for the Tru64 5.x operating
system.
1. Confirm the installation of the appropriate version of Tru64 UNIX. For the Tru64
Figure 7. Example of the sizer -v command
2. Ensure that you are at patch level 7 and that all kernel options are active. For

Installing the KGPSA-xx adapter card in an Tru64 UNIX host system

This section lists the steps you must perform to install the KGPSA-xx adapter card.
1. Shut down the HP AlphaServer host system.
2. Use the procedures provided by the manufacturer of the adapter card to install
3. Restart the host (nonclustered configurations) or each cluster member
4. Bring each host system to a halt condition at the console level.
5. Type set mode diag at the HP AlphaServer console to place the console in
6. Type wwidmgr-show adapter to confirm that you installed each adapter properly.
7. If necessary, update the adapter firmware.
30
DS6000 Host Systems Attachment Guide
UNIX 5.x operating system, use the sizer -v command to confirm installation.
Figure 7 shows an example of what is displayed when you use the sizer -v
command.
# sizer -v
v5.x
#
Compaq Tru64 UNIX V5.1A (Rev. 1885); Tue Sept 24 14:12:40 PDT 2002
Tru64 UNIX cluster configurations, you must install patch 399.00 with patch
security (SSRT0700U). For information about other patches for this version,
refer to the documentation from HP.
the KGPSA-xx host adapter.
(clustered configurations).
diagnostic mode.
See Figure 8 on page 31 for an example of what you see when you type set
mode diag and wwidmgr -show adapter.