Table of Contents
Advertisement
Paper remaining sensor removal
1. Remove the paper feed frame.
2. Remove the two screws from the paper remaining detection
sensor and remove the sensor.
Paper size sensor board assembly removal
1. Open the top unit and remove the RIP cover, RIP board, RIP
box, and electronic box. Remove the upper cassette, front cover
B, and back cover. Open the turn guide and paper feed cover
and remove the duplex unit. Remove the left side cover and
power supply A.
2. Disconnect the connector and remove the two screws from the
paper size sensor board, and remove the board.
3. Remove the screw from the size detection lever, and remove the
lever.
5055-xxx
Repair information
4-39
Advertisement
Table of Contents
