Channel Value; Safety Precautions - ADJ Vortex 1200 User Instructions

Vortex 1200
Channel Value
28
0 - 69
70 - 79 BLACKOUT WHILE PAN/TILT MOVE
80 - 89
90 - 99 BLACKOUT WHILE RGBW CHANGE
100 - 109
110 - 119 EFFECT WHEEL MOTOR RESET
120 - 199
200 - 209
210 - 249
250 - 255
29
0 - 20
21 - 40
41 - 60
61 - 80
81 - 100
101 - 255 DEFAULT TO UNIT CURVE SETTING
Vortex 1200
Stand By Blackout the unit
Function 1. Sync. Strobe
Select Show
1-4
2. Two-light strobe
3. Sound Strobe
Mode Sound (LED OFF) LED ON
ADJ Products, LLC - www.adj.com - Vortex 1200 User Manual Page 30
29 Channel Mode
Function
SPECIAL FUNCTIONS
NO FUNCTION
NOTHING
NOTHING
PAN & TILT MOTOR RESET
ALL MOTOR RESET
NOTHING
SOUND ACTIVE
DIMMER CURVES
STANDARD
STAGE
TV
ARCHITECTURAL
THEATRE
UC3 Control
1. Hold to change Master Pan position
2. Hold to change Master Tilt position
3. Hold to change Master Dimmer
4. Hold to change Slave Pan position
5. Hold to change Slave Tilt position
6. Hold to change Slave Dimmer
LED fast blinking
Vortex 1200
• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture
• Do not spill water or other liquids into or on to your unit.
• Be sure that the local power outlet match that of the required volt-
age for your unit.
• Do not attempt to operate this unit if the power cord has been
frayed or broken. Do not attempt to remove or break off the ground
prong from the electrical cord. This prong is used to reduce the risk
of electrical shock and fire in case of an internal short.
• Disconnect from main power before making any type of connection.
• Do not remove the cover under any conditions. There are no user
serviceable parts inside.
• Never operate this unit when it's cover is removed.
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6" (15cm) between this device and a wall.
• Do not attempt to operate this unit, if it becomes damaged.
• This unit is intended for indoor use only, use of this product out`
doors voids all warranties.
• During long periods of non-use, disconnect the unit's main power.
• Always mount this unit in safe and stable matter.
• Power-supply cords should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them,
paying particular attention to the point they exit from the unit.
• Cleaning -The fixture should be cleaned only as recommended by
t he manufacturer. See page 32 for cleaning details.
• Heat -The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances (inclu-
d ing amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The appliance does not appear to operate normally or exhibits a
marked change in performance.
ADJ Products, LLC - www.adj.com - Vortex 1200 User Manual Page 4

Safety Precautions