ADJ Vortex 1200 User Instructions page 13

Vortex 1200
Channel Value
12
120 - 127
128 - 135
136 - 143
144 - 151
152 - 159
160 - 167
168 - 175
176 - 183
184 - 191
192 - 199
200 - 207
208 - 215
216 - 223
224 - 231
232 - 239
240 - 247
248 - 255
13 0 - 255 PAN/TILT MACRO SPEED FAST-SLOW
14
0 - 69
70 - 79 BLACKOUT WHILE PAN/TILT MOVE
80 - 89
90 - 99 BLACKOUT WHILE RGBW CHANGE
100 - 109
110 - 119
120 - 199
200 - 209
210 - 249
250 - 255
15
0 - 20
21 - 40
41 - 60
ADJ Products, LLC - www.adj.com - Vortex 1200 User Manual Page 23
15 Channel Mode
Function
PAN/TILT MACROS
MACRO 15
MACRO 16
MACRO 17
MACRO 18
MACRO 19
MACRO 20
MACRO 21
MACRO 22
MACRO 23
MACRO 24
MACRO 25
MACRO 26
MACRO 27
MACRO 28
MACRO 29
MACRO 30
MACRO 31
SPECIAL FUNCTIONS
NO FUNCTION
NOTHING
NOTHING
EFFECT WHEEL MOTOR RESET
PAN & TILT MOTOR RESET
ALL MOTOR RESET
NOTHING
SOUND ACTIVE
DIMMER CURVES
STANDARD
STAGE
TV
Vortex 1200
will automatically go into stand by mode.
• Hold - If the DMX signal is lost the fixture will stay in the last
DMX set up. If power is applied and this mode is set, the unit will
automatically go into the last DMX set up.
• Show - If the DMX signal is lost or power is applied, the unit will
automatically go into Show mode.
3. Press ENTER to confirm your desired set up.
Sound State
- In this mode the unit will run in sound
active mode.
1. Press the MENU button until "Sound State" is displayed, press
ENTER.
2. Either "On" or "Off" will now be displayed. Use the UP or
DOWN buttons to toggle between "On" and "Off".
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
- This function will let you adjust the
sound sensitivity of the sound active mode.
1. Press the MENU button until "Sound Sense" is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (least sensitive)
and 100 (most sensitive).
3. Press ENTER to set you desired level.
Pan Invert
- Pan Inversion
1. Press the MENU button until "Pan Invert" is displayed, press
ENTER. Either "Yes" or "No" will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until "Yes" is displayed, press ENTER to confim. To deactivate
ADJ Products, LLC - www.adj.com - Vortex 1200 User Manual Page 12
System Menu