ADJ LED Beam Scan User Instructions

User Instructions
5/09
American DJ
®
6122 S. Eastern Ave.
Los Angeles CA. 90040
www.americandj.com
LED Beam Scan
Unpacking:
Thank you for purchasing the LED Beam Scan by Ameri-
can DJ . Every LED Beam Scan has been thoroughly tested and has
®
been shipped in perfect operating condition. Carefully check the ship-
ping carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your fixture for any
damage and be sure all equipment necessary to operate the unit has
arrived intact. In the event damage has been found or parts are miss-
ing, please contact our toll free customer support number for further
instructions. Please do not return this unit to your dealer without con-
tacting customer support first.
Introduction:
The LED Beam Scan is a DMX intelligent, moving head,
mini LED pinspot. The LED Beam Scan can operate as a stand alone
fixture or in a Master/Slave configuration. The LED Beam Scan has
three operating modes; a sound active, show mode, DMX controlled.
For best results use fog or special effects smoke to enhance the beams
projections.
Customer Support:
American DJ
support line, to provide help and to answer any question should you
encounter problems during your set up or initial operation. You may
also visit us on the web at www.americandj.com for any comments or
suggestions. Service Hours are Monday through Friday 9:00 a.m. to
5:00 p.m. Pacific Standard Time.
Voice: (800) 322-6337
Fax: (323) 582-2941
E-mail: support@americandj.com
To purchase parts online visit http://parts.americandj.com
Warning!
To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Warning!
This may cause severe eye damage. Avoid looking directly
into the light source at all times!
American DJ - www.americandj.com - LED Beam Scan Instruction Manual Page 2
®
General Information
provides a toll free customer
®