Table of Contents
Advertisement
Remote Messaging
Remote Messaging is a Voice Mail feature that can be enabled by your installer. If
your mailbox has this feature turned on, you may program a remote programming
"cascade" (a series of up to nine telephone numbers) for the Voice Mail system to call
when your mailbox receives new messages.
Each mailbox can have a Primary and an Alternate cascade of numbers. Each cascade
can be programmed to be used during specific days and times. For example, if you
want to be paged when you receive a message from 5-10 PM on weekdays, you can
set up a Primary cascade. If you also want to receive pages for messages marked "pri-
ority" on the weekends, your Alternate cascade could be set for all day on Saturdays
and Sundays. If you need to enter more than one number (just in case the pager num-
ber is busy or out of service), you can enter up to nine numbers for each cascade.
If for some reason Voice Mail is not able to use your remote notification (due to busy
facilities or invalid programming), your mailbox will receive a message stating that
notification could not be completed.
To set up remote messaging:
— Enter your mailbox as described on
— Press
— Press
— A prompt tells you what the cascade's current status is. Perform one of the fol-
lowing steps:
•
To program a cascade level, press
wish to program (1-9). You then have the following options:
— To enable or disable the cascade level, press
— To set up or change an extension or telephone number, press
— To set up or change a pager number, press
•
To set up time of day for notification, press
the message notification to start and stop. Enter the times with two digits for
the hour and two digits for the minutes. If entering the time in 12-hour for-
mat, you will be prompted to press
Note
ing times to be the same.
Continued on next page
AXXESS Standard and Basic Keyset and AXXESSORY Talk Guide
.
5
to set up a Primary cascade, OR press
1
level until a notification number is programmed.)
press
if it is an extension number, OR press
1
number. Then enter the number.
If you wish to have 24-hour notification, program the starting and end-
page
38.
to set up an Alternate cascade.
2
and enter the number of the level you
1
. (You cannot enable the
1
. Then enter the number.
3
. Then enter the time you want
2
for AM or press
1
. Then
2
if it is an outside
2
for PM.
2
47
Advertisement
Table of Contents
