Hasler HJ950C Operating Manual page 18

SECTION 2
INSTALLING THE PRINTER
8. Once the Ribbon Cable is properly connected to the Service Station Circuit Board; gently slide the
Service Station, wiper roller end first, into the Service Station Slot until it stops. The Service
Station fits into the slot immediately above the Ink Tank slots.
NOTE: The Ink Tank Door must be open to perform this procedure.
9. Look down through open area of the Printhead
Cartridge compartment, in the top of the Print
Engine, to make sure the Service Station is aligned
with the "Bar"; as shown.
IMPORTANT! Service Station must perfectly
aligned with "Bar" to prevent misalignment and
jamming of the service station.
14
Ribbon Cable
Connected to Service
Station Circuit Board
Wiper Roller end of
Service Station