Hasler HJ950C Operating Manual page 17

5. Carefully remove the Service Station from its packaging.
NOTE: Loose parts may fall out. Keep wiper roller side facing up, when removing the packaging.
Make sure latches on the Wiper Roller are fully latched before installing the Service Station.
6. Slide the Cable Securing Latch open on the Service Station Circuit Board; as shown below.
Closed
7. Insert the Ribbon Cable (blue side up) into the space under the Cable Securing Latch [1].
Make sure the ribbon cable is pushed in all the way and is NOT crooked. Then close the Cable
Securing Latch [2].
Open
CAUTION!
Check the latch at each end of
Opened
Close
1
SECTION 2
INSTALLING THE PRINTER
the wiper roller.
2
13