Cli Command Groups; Table 15: Command Group Index - Edge-Core ES4528V-38 Management Manual

CLI C G
OMMAND ROUPS
The system commands can be broken down into the functional groups
shown below
.

Table 15: Command Group Index

Command Group Description
System Configures general system settings, including descriptive
information, user name and password, rebooting the
system, setting the time zone, configuring the log levels
to display, and filtering management access to the switch
through specified IP addresses.
IP Configures IP settings, including IPv4 or IPv6 addresses,
DHCP, DNS, DNS proxy, as well as SNTP
Auth Controls management access through RADIUS or
TACACS+ authentication servers
Port Configures connection parameters for ports, power
saving mode, and cable testing
Aggr Configures static port aggregation, including member
assignment, and load balancing methods
LACP Configures Link Aggregation Control Protocol
RSTP Configures Rapid Spanning Tree Protocol
Dot1x Configures IEEE 802.1X Port Authentication
IGMP Configures IGMP snooping, query, throttling, and filtering
LLDP Configures Link Layer Discovery Protocol
MAC Configures the MAC address table, including learning
mode, aging time, and setting static addresses
VLAN Configures VLAN port members and port attributes
PVLAN Configures private VLANs and isolated ports
QoS Configures quality of service parameters, including
default port queue, default tag assigned to untagged
frames, input rate limiting, output shaping, queue mode,
queue weight, quality control lists, storm control, DSCP
remarking, and DSCP queue mapping
ACL Configures access control lists, including policies,
responses, and rate limiters
Mirror Mirrors data to another port for analysis without affecting
the data passing through or the performance of the
monitored port
Config Saves or restores configuration settings
SNMP Configures SNMP community strings, trap managers, and
basic settings for SNMPv3
HTTPS Enables or disables HTTPS, or automatically redirects
management access from HTTP connections to HTTPS
SSH Enables or disables management access via SSH
UPnP Configures UPnP protocol settings
DHCP Configures DHCP Relay and Option 82 Information
– 201 –
| Using the Command Line Interface
C 8
HAPTER

CLI Command Groups

Page
203
213
223
233
243
249
255
267
277
287
295
301
307
311
323
331
333
335
357
361
363
367