| Performing Basic Diagnostics
C
6
HAPTER
Running Cable Diagnostics
R
C
D
UNNING
ABLE
IAGNOSTICS
Figure 65: ICMP Ping
The VeriPHY page is used to perform cable diagnostics for all ports or
selected ports to diagnose any cable faults (short, open, etc.) and report
the cable length.
P
ARAMETERS
These parameters are displayed on the VeriPHY Cable Diagnostics page:
◆
Port – Diagnostics can be performed on all ports or on a specific port.
Cable Status – Shows the cable length, operating conditions and
◆
isolates a variety of common faults that can occur on Category 5
twisted pair cabling.
W
I
EB
NTERFACE
To run cable diagnostics:
Click Diagnostics, VeriPHY.
1.
Select all ports or indicate a specific port for testing.
2.
Click Start.
3.
If a specific port is selected, the test will take approximately 5 seconds. If
all ports are selected, it can run approximately 15 seconds. When
completed, the page refreshes automatically, and you can view the cable
– 184 –