System Access Ipv6 Add - Edge-Core ES4528V-38 Management Manual

| System Commands
C 9
HAPTER
system access ipv6
add
This command adds IPv6 addresses that are allowed management access
to the switch through various protocols.
S
YNTAX
system access ipv6 add access-id start-ip-addr end-ip-addr
[web | snmp | telnet]
access-id - Entry index. (Range: 1-16)
start-ip-addr - The starting IPv6 address of a range.
end-ip-addr - The ending IPv6 address of a range.
web - Adds IP address(es) to the web group.
snmp - Adds IP address(es) to the SNMP group.
telnet - Adds IP address(es) to the Telnet group.
D S
EFAULT ETTING
None
C U
OMMAND SAGE
An IPv6 address must be formatted according to RFC 2373 "IPv6
◆
Addressing Architecture," using 8 colon-separated 16-bit hexadecimal
values. One double colon may be used to indicate the appropriate
number of zeros required to fill the undefined fields.
To set a single address for a entry, enter the same address for both the
◆
start and end of a range.
If anyone tries to access a management interface on the switch from an
◆
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
You cannot delete an individual address from a specified range. You
◆
must delete the entire range, and reenter the addresses.
E
XAMPLE
System>access ipv6 add 1 2001:DB8:2222:7272::72 2001:DB8:2222:7272::72 web
System>
– 210 –