Required Tools And Equipment - NEC Versa LX User Manual

Required Tools and Equipment

All Versa SX corrective maintenance procedures can be performed using the
following tools:
n
Tweezers
n
Small flat-head screwdriver
n
Small Phillips screwdriver
n
Right-angled dentist style probe.
Disassembly
This section contains step-by-step disassembly procedures for the system.
Reassembly is the reverse of disassembly. Each procedure is supported by a
simplified disassembly illustration to facilitate removal. The Illustrated Parts
Breakdown and parts lists for the system unit are shown in Section 5.
For complete disassembly of the system, follow the disassembly order listed
below. To reassemble, follow the table in reverse order.
Level of
Disassembly
Preparation
Keyboard (1)
Top Cover (2)
Bottom Cover
When disassembling the system unit, follow these general rules.
n
Do not disassemble the system into parts that are smaller than those
specified in the procedure.
n
Label all removed connectors. Note where the connector goes and in
what position it was installed.
3-2 Disassembly and Reassembly
Versa SX Disassembly Sequence
Components Available at Level of
Disassembly (number of screws)
Battery, VersaBay III Device, Memory Module
Bay cover (1)
Hard Drive (2)
Switch Settings
LED Status/Power Switch Board (1)
VersaGlide Assembly (4)
LCD Panel Assembly (4)
Bridge Battery
CMOS Battery
CPU Assembly (1)
Speaker Assembly
Fan Duct and Fan (1)
Hard Drive Bracket (2)
Main Board
Microphone
PC Card Assembly (4)