Assembly; Remove The Generator From The Shipping Carton; Install The Wheel Kit; Install The Support Leg - Champion 40730 Owner's Manual & Operating Instructions

40730
ENGLISH
Your generator requires some assembly. This unit ships
from our factory without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the assembly of your
generator, call our help line at 1-877-338-0999. Please
have your serial number and model number available.

Remove the Generator from the Shipping Carton

1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the
generator.
3. Carefully cut each corner of the box from top to
bottom. Fold each side flat on the ground to provide a
surface area to install the wheel kit and support leg.

Install the Wheel Kit

CAUTION
The wheel kit is not intended for over-the-road use.
1. Before adding fuel and oil, tip the generator on it's side.
2. Slide the wheel pin roll (#34) through the wheel
(#35) from the outside.
3. Slide the pin roll through the mount point on the
frame.
4. Secure the Garter Spring B (#36).
5. Repeat steps 2-4 to attach the second wheel.

Install the Support Leg

1. Align the Support Foot (#65) with the holes on the
frame.
2. Insert an M8x16 flange bolt (#67) through each
hole from the bottom.
3. Secure each bolt with an M8 nut (#46) from the
top.

Install the Handle

1. Place the handle over the mounting channel on the
frame.
2. Secure the handle to the frame using the two
M8x45 handle bolts (#45).
3. Place an M8 lock nut (#46) on the end of each bolt
and fasten securely. DO NOT over tighten the lock
nuts.

ASSEMBLY

8
REV 40730-20130609