Cleaning And Maintenance; Safety Advice; Cleaning - Bartscher 135.100 Instruction Manual

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power socket (pull the power plug!!!) and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and the
plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not
use any kind of pressure water jet for cleaning the device!

6.2 Cleaning

Clean the device on a regular basis.
o
In order to clean the stirring shaft, simply fill the shaker with approx. 250 ml of a
o
warm soap-water solution, insert it into the device and set the switch for about 30
seconds to speed level „1" (slow). Afterwards, set the switch to position „O" (OFF)
and pour away the soap-water solution. Repeat the procedure with warm water
only in order to rinse the stirring staff. Dry the stirring staff with a soft, dry cloth.
Rinse the shaker with warm water and dry it thoroughly.
o
For thorough cleaning you may as well put the shaker and the stirring staff into the
o
dishwasher. For this purpose, detach the stirring staff (pull off downwards).
NOTE!
Stirring staff and shaker are dishwasher-proof!
Wipe the housing of the device with a soft, damp cloth and dry off thoroughly
o
afterwards.
Only use a soft cloth and make sure you never use any kind of abrasive agents or
o
pads which could scratch the surface.
After the cleaning procedure, you should use a soft and dry cloth to wipe dry and
o
polish the surface.
Make sure the device has been cleaned properly before storing it in a dry place.
o
- 25 -