Table of Contents
Advertisement
5.2 Installation and connection
•
Discard the complete packing material after unpacking the device.
•
Place the device on an even, safe spot which is dry and supports the weight of the
device.
•
Do not set up the device near containers filled with water or other liquids.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
5.3 Operating
•
Insert the stirring staff by tilting the swivel head upwards and pushing the stirring
staff into the fixture until it snaps in.
•
Clean the stirring staff and the shaker before use (see chapter 6.2 „Cleaning").
•
Wipe the device from the outside using a damp, soft cloth.
•
Insert the power plug of the device into a grounded single socket.
•
Make sure the switch is set to position „O".
•
Fill the desired ingredients into the shaker.
ATTENTION!
When filling the shaker, make sure the mark for maximum filling quantity is not
exceeded (upper mark, approx. 350 ml).
Make sure the shaker is filled at least up to the minimum filling mark (lower mark,
approx. 150 ml) as the stirring staff does not reach the ingredients otherwise!
•
Mount the shaker to the device. Make sure the upper part of
the shaker is behind the cup/ shaker clamp.
•
The bottom edge of the shaker must be mounted firmly on top
of the cup support as only this way the stability and the contact
of the shaker to the safety switch is ensured.
ATTENTION!
User the delivered shaker only!
- 23 -
Advertisement
Table of Contents
